Then double tap the light paddle switch and hold on the second tap. To dim the light, start with the light in the off position.Release the paddle switch when the mode changes.

To change either the light/laser to pulse or steady mode, press and release the appropriate paddle switch, wait one second, then press and release the the same paddle switch for two seconds.

Press and release again to turn the laser off.

To activate the light and laser simultaneously, press and release both paddle switches using the recessed channel.

To activate the light, press and release the bottom paddle switch.

To activate the laser, press and release the top paddle switch.

TFB REVIEW: LaserMax Spartan – Elevation Adjustment Two screws double to both mount the Spartan as well as secure the battery compartment:

Tighten (not over tighten) until the Spartan is securely mounted on the rail.

Close the battery door/left side mount and insert the hex screws.

Make sure the internal alignment plate locks into a rail groove.

Line up the Spartan on the rail section closest to the position to where your trigger finger can easily manipulate the paddle switches.

Install a fresh battery (not included).Remove the hex screws with the included hex wrench.Almost too light: my first thought was ‘is this going to withstand repeated punishment’? The LED sits on the right hand side, the laser in the middle (and slightly above), in line with the bore axis and the battery compartment on the left.

Lasermax adjustment tool size